When you are removing asbestos the main objective is to keep the dust that is released during the process as minimal as possible. This can be achieved without breaking the sheets, wetting the sheets down with water or spraying the sheets with a PVA glue mixture. The correct removal techniques calls for patience because a lot of individuals while removing asbestos tend to be tempted often breaking the sheet to save on time. When you break the sheet while removing asbestos even if you have watered it down to wet it, the sheet will probably release fibres in the air. On that point you will have no other option rather than breaking the sheeting and in this case dust will find its way to the air through hosing the sheet down as it is broken.
Moreover, while stacking the sheets after you remove them, you should place them on top of another. Do not slide them against another because the friction caused between sheets will make the fibres to be released even more.
The following article outlines asbestos removal Queensland - tips and advice
Asbestos Fencing removal
Asbestos fencing removal to be honest is usually a hard task since hand digging of the sheets is required. In order to do the job properly it requires you to dig out deeper and remove the entire sheet. If in case some or part of the sheet remains intact with the ground when time comes to put the fence asbestos can actually get in the way. More so you must be aware that you cannot deviate around the asbestos as the fence will become crooked. Conversely the neighboring sheet will end up with a bigger backyard and the other one relatively smaller.
Moreover bolts holding the sheets in place might have rusted and pose difficulty in removing them. You can consider utilizing a powered battery rattle gun which has a flat blade attachment for driver screw to remove them. Also you will have another person or a partner if we call him or her as so on the other side of the fence. They must be having an adjustable spanner that they will use to hold the bolt as the powered battery rattle gun is being used to remove the bolts holding the sheet. To hire asbestos removal experts visit iasbestosremovalbrisbane.com.au
Asbestos cladding removal
Asbestos cladding can be removed using a variety of ways. Basically asbestos cladding usually involves nails removal from the sheeting. These nails can be removed in various means the most popular includes using the following apparatus:
- Nail puller
- Nail punches
- Cold chisel
Nail pullers are the best option to consider for removing nails. They do not tend to crack the sheeting as well as they are a bit faster. However, you must be careful enough since they create dust when removing nails.
Cold chisels usually require you to knock the nail head by use of chisel place next to the nail and hammering over it. It is usually faster if you are removing many nails but it cracks the sheets sometimes.
Nail punches are the cleaner method for nail removal from asbestos but it is a very slow technique. Hammer the punch after you put it on the head of the nail, it drives the nail back into the sheet.
Safety equipment
- Respirator
While choosing the respirators to use during the process you can select from the following:
- Paper
- Half face mask
- Full face mask respirators
If you consider full mask or half face mask respirator you can either opt p2 or p3 filter. A properly worn respirator on full face will provide you with maximum protection than considering a half face mask. This is because the full face mask will not allow asbestos to get to your skin if worn well with an overall.
- Coverall
Make sure that the coverall you are using are highly rated for usage while working with asbestos.
- Boots
Boots for asbestos removal should not be having steel caps or races. The best choice boots for asbestos removal should be steel capped gumboots. This is because you can carry asbestos to your home from your footwear.
- Gloves
Do not use fabric gloves as asbestos will become trapped in the fabric. Consider using dish washing gloves for asbestos removal.
While cleaning and dumping the asbestos make sure you wrap it in black builders plastic. You can find those bags from building stores in Australia. Consider buying 4 meter high and 50 meter long black builder’s plastic as they will give you little job in wrapping the sheets. In addition, depending on the disposal facility you visit remember you will be required to wrap the sheets in groups of three or five or perhaps in bundles of thirty.
References
